Looking to get a cork handle replaced on a rod ( half wells ) , nothing else just the cork . Any ideas on who could do this and a rough price guide would be greatly appreciated .

Thanks

Stephen .

Stan at Alba rods ( if hes back at work yet )
Scott

__________________


Harbour Lights Flyfishers

Thanks Scott I shall look into that

David Norwich must be a good bet.....done similar for me, recommended.

Peter

Get somebody local - postage likely fierce - and you may get to pay for a new reelseat depending on which way the job gets done !

Take care

Steve P

I will pm you Stans details.
He is back to work

__________________
www.tintotroutfishery.co.uk
www.anglersholidaycottages.co.uk

I have stripped down an HM3 10' 7/8 with just the reel seat left on the blank waiting to put a new cork handle on it . Bloke was selling new corks and I have sent him a few PMs but still waiting. Does anybody know where I can get a good quality cork handle for it without breaking the bank. Thanks in advance for any replies

__________________
I've not lost my mind, it's backed up on disk somewhere.

Campbell

To give you a guide I recently had a new cork handle and reel fiting put on and it cost m3 £35 ..

Andy

New cork handles from here, not difficult to DIY

Handles & Reel Fittings

__________________
Jeff

Many thanks for all your suggestions guys im now sorted