Looking to order up a blank but when I measured out the 5ft length of the Harrison Balista I didn't think it was protable enough.

Anyone know of a decent blank for about 60 - 120 pounds?

Thanks
AL

Nobody know any?

What have you found so far and where have you looked?

Have looked at Harrison rod but most of them are 6/7 weight the 6wt is only a 2 piece and I think it'll be a bit big.
Most of the others I have seen are 5 or 7wts.

Thanks
AL

Try asking if they make what you want - stock lists are a guide only

Why not go for the harrison lorhic blanks, but dosnt the ballista come in 3 or 4 sections too i could do with a 2 pc 6# ballista as the wife broke my one av a look here if you havnt already http://www.meadowfishery.com/prods/pc43.html not sure about the traditional range ??

__________________
If in doubt, get the montys out

Intelligence is relative to your environment

Thanks will email harrisons and see if they have any 3/4 piece models.

Hi Roll Cast, Give Steve a buzz or check himout on his site. He may be able to help Ok.

Regards

Stuart

I had a Harrison Ballista 5 weight 10' which I made up into a very good rod. It felt undergunned with a WF5 on it; was great with a WF6 and coped well enough with WF7 if necessary. The two sections are a bind when it comes to air travel these days.

Contact Martin Cloke at Aquarius rods in Perth his number is on website aquariusfishingtackle.

Martin been build rods using Harrison Blanks for over 30 years and im sure he would help you out.